Schwank STR-JZ Manuel du propriétaire télécharger pdf (Page 25)

SP-MSJR-BX-08C

STR-JZ Manual

RD: NOV 2006

RL: 8C

Page 21

15. LIGHTING INSTRUCTIONS

Refer to the lighting instructions on the outside

cover of the burner housing. Again, if the unit

locks out on safety, main power to the unit must

be manually interrupted for a 30 second reset

period before the heater can be restarted.

NOTE:

On initial installation, the unit may

lock out on safety owing to the

length of time required to bleed air

from the gas piping system.

16. RECOMMENDED MAINTENANCE

1. Prior to each heating season a qualified service agency shall thoroughly inspect the heater, gas and

electrical supplies, thermostat connections, the venting and combustion air duct. Worn parts shall be

repaired or replaced as required.

2. Check the inlet air opening and the blower periodically, cleaning off any lint or foreign matter, as it

is important that the flow of combustion and ventilation air must not be obstructed.

3. Lubricate Blower motor, by adding several drops of oil to oil ports located on the left hand side of

the motor.

4. Inspect and ensure that the flame inspection port is clean and free of defects.

THE SCHWANK TUBE HEATER BURNER IS COMPLETELY FACTORY ASSEMBLED AND

TESTED. ANY ALTERATION VOIDS THE CSA CERTIFICATION AND MANUFACTURER’S

WARRANTY. FOR ADDITIONAL INFORMATION, CONTACT YOUR LOCAL DISTRIBUTOR

OR SCHWANK.

1 2 ... 20 21 22 23 24 25 26 27 28 29 30 ... 36 37

Pas de commentaire

Schwank STR-JZ Manuel du propriétaire Page 25